-40%
MS3 Pro Plug & Play 1999-00 Miata Engine Management System standalone ECU TURBO
$ 633.07
- Description
- Size Guide
Description
Brand new megasquirt 3 plug and play Pro Authorized MS re-seller, have your miata running in less than an hour !Description
MegaSquirtPNP Pro – Plug-N-Play Standalone Engine Management System
for 1999-2000 USDM Mazda Miata with Manual Transmission
MS3-Pro based MSPNP takes plug and play engine management to the next level!
Easy to Use and Install!
MegaSquirtPNP Pro Model #MM9900 Features:
Fully Plug and Play Installation – No wiring required for basic functionality
Average install time is under 1 hour!
Base map is pre-loaded to help your engine start on the first turn of the key
Real time tuning and data logging with a laptop connection
8 GB internal data logging with built in SD card
Supports most aftermarket wideband sensors
Fully Tunable Engine Control!
16×16 Fuel Tables allow high resolution tuning
16×16 Ignition Tables
Multiple Acceleration enrichment strategies
Closed Loop Idle Speed Control
Air Conditioner Control
Programmable voltage regulator control
4 sequential fuel injector channels with individual trim tables
Onboard peak and hold drivers support both high and low impedance injectors – No external ballast resistor is needed!
Allows removal of stock airflow meter
Advanced Feature Set (Included!)
12×12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
VVT support if swapping to a later VVT motor
Multiple traction control strategies
Built-in 3-step rev limiter/launch control with flat shift and burnout rev limiter
Real time barometric correction
Internal 4-bar MAP sensor reads up to 44PSI of boost
Overboost protection
Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit – stock boost control solenoid does not allow adjusting of boost level)
Rally style anti lag
Water injection control – on/off or variable
Knock sensor input with adjustable sensitivity, crank angle windowing, and more
Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
Input for flex fuel sensor – switch between E85 and gasoline on the fly!
CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors…..the possibilities are limitless!
What you get in the box:
MegaSquirtPNP-Pro MM9900 ECU
MSPNP RS232 serial tuning cable, 6′ (USB adapter sold separately, if needed)
Tuning Software and Documentation on USB memory stick
6′ Vacuum Hose for MAP Signal and ‘T’ fitting
Four Screws for ECU mounting
Registered version of TunerStudio and MegaLog viewer included